If you want to Failover the server, just Click it.DoubleTake/Carbonite Backup and Recovery Solutions ConsultingĭoubleTake Software, acquired and rebranded by Carbonite, publishes a family of products designed to provide small companies a variety of affordable solutions for backing up and recovering business-critical applications such as Exchange, Microsoft SQL, Blackberry, and SharePoint. If data between source and target already sync, then Mirror Status will be Idle.Īfter That, Failover button will be shown. To see the Job that we created, choose Manage Jobs. I like green □Ĭlick Finish, and job will automatically run.Ģ2. Double-Take will check all the option that you have made. If you have bandwith issue, set on this sub-menu. Choose Mirror Files to the Target server when verifying, choose Block checksum.Ģ0. Interval can be set when data traffic not crowded. Then choose Use block checksum for comparasions.įor data check, choose Enable schedule Verification. I do some little change on Mirror, Verify & Orphaned Files Sub-menu.Ĭhoose Mirror different files if you want Double-take to send only data who change after synchronize. I didn’t use any script, so i skip this sub-menu.ġ9. If you need snapshot and compression, choose it. On mappings column, make sure Source Path and Target Path correct.Ĭhoose One to One if you have one source and one target.ġ7. On Send data to the target server using this route drop down menu, choose replication IP. There’s several thing that i changed on Network Route & Folder Selection sub-menu. On Failover Options sub-menu, i didn’t change anything.ġ6. Failover Monitor Sub-menu, choose which IP that we want to monitor when replication process run.ġ5. Make sure Source and target correct, see Job name column.ġ4. This menu had some sub-menus that must be considered. Choose server that we want to set as target server. Include / Exclude column shows which folder that will be replicate. Files column shows the folder contains.Ĭhoose Add Rule if you want to add the folder or file. On Replication Rules menu, choose which file or application that we want to replicate. If you only want replicate some data or just application, choose Replication Rules.ġ0. For Failover, choose Full-Server Failover and then Next. Choose server that we want to set as source server. Choose Protect files and folders or entire server. To start replication process, click Get Started. To make server go into the folder, right click on server and choose manage Group Assignment.Ħ. For make it easier to manage servers, we can make folders for them.Ĭlick, insert folder name. All the servers that we added will be shown on Manage Server menu. ![]() ![]() Or we can just click OK if we finish adding the server.Ĥ. If you want to add another server, just insert again the hostname or IP, user and password. Insert user and password on user name column and password column, user name that we used to install Double-take on source and target server.Ĭlick Add, the server that we add will show on the right column. On server column, insert the hostname or IP Address from server that we want to add. If there’s already server added, we could see it on Manage Servers.ģ. ![]() On Double-Take Console, add Servers who will be Source and Target. Start > Programs > Double-Take > Double-Take ConsoleĢ. After Installation completed, this is what i did, step-by-step.ġ. On This Post, i will show you how i did used Double-take to perform Replication and Failover using two servers (Source and Target). On previous post, i’ve shown you some rules that might be helping when installing Double-take.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |